The feeding and unloading device is placed on the bench. When the workpiece (plate) is emptied and pulled down from the main engine, the motor 7 (shown) starts through the transmission shaft (2, 3, 4, 5, 6).
Move the chain to turn, push block 1 from the lower chain to the upper chain, push from the side of the workpiece
The workpiece, several pushing push the workpiece at the same time, the workpiece is pushed upside down on the roller of the inclined plane of the blanking box,
In order to slide into the material box by gravity. The push can turn to the lower chain, close to the switch and sense the push.
Block, send a signal to the control center, and the control center issues instructions to stop the motor 7 from
The push block stops in the chain below and completes a working cycle.The feeding and unloading device is placed on the bench. When the workpiece (plate) is emptied and pulled down from the main engine, the motor 7 (shown) starts through the transmission shaft (2, 3, 4, 5, 6).
Move the chain to turn, push block 1 from the lower chain to the upper chain, push from the side of the workpiece
The workpiece, several pushing push the workpiece at the same time, the workpiece is pushed upside down on the roller of the inclined plane of the blanking box,
In order to slide into the material box by gravity. The push can turn to the lower chain, close to the switch and sense the push.
Block, send a signal to the control center, and the control center issues instructions to stop the motor 7 from
The push block stops in the chain below and completes a working cycle.
